Alma Kelley Valves April 14th, 2019 - 12:16:45
Needle Valves are designed in many different materials. The valve is generally metal - here stainless steel, or a steel alloy, brass, or bronze are most often used, The seat is usually made from an elastomeric material such as PVC, CPVC, PTFE or a suitable type of the wide range of plastics and thermoplastics on the market. Valves are available in different materials - here customer choice will be determine by the specific application the valve is to be used for, along with the conditions it will be subject to. You have to take into account whether the fluid is particularly high or low in temperature, likelihood of corrosion, and how much wear the valve will be subject to you. Swagelok will be able to consult with you, and advise you what type of valve is best for the application you require it for. Swagelok Tube Fittings are available in additional Valve Body Materials on request - these include carbon steel and 25Cr super duplex stainless steel.
Many people usually get motivated to get titanium valves because they want to increase the maximum revolutions per minute that they get. An engine that has titanium valves also tend to operate better in the long run, as it receives lesser stress. Though many drivers feel that these valves are quite pricey, many also think that they are a good investment. They are apparently good for the engine, as well as the total performance of the car. However, it is just as important to check the quality of the valves being sold in the market as not all of them are of the same quality.
The last one is the valve type and sizing. Over-sizing of valves sometimes occurs when trying to optimize process performance through a reduction of process variability. Over-sizing the valve may hurt process variability in two ways. First, the oversized valve puts too much gain in the valve, leaving less flexibility in adjusting the controller. Best performance results when most loop gain comes from the controller. The second way oversized valves hurt process variability is that an oversized valve is likely to operate more frequently at lower valve openings where seal friction can be greater, particularly in rotary valves.
All in all, step by step the valve manufacturing becomes one of the important sectors in the mechanical industry. There are a lot of applications for the valve. It is closely connected with our daily life. For example, the tap used for running water pipe and the reducing valve used for liquefied petroleum gas stove are the valves. What's more, it is the essential part for different mechanical equipments such as gas engine, steam engine, compressor, pump, vehicle, ship or aerocraft.
Swagelok produces a variety of Check Valves to meet every need. All Check Valves are factory tested for crack and reseal performance with a liquid leak detector. Check Valves with fixed cracking pressures are cycled six times prior to testing. Every valve is tested to ensure it seals within 5 s at the appropriate reseal pressure. Check Valves with adjustable cracking pressures are tested at two pressure points. Every Valve is tested at a low-pressure setting and at a high-pressure setting, and all must seal within 5 s at the appropriate reseal pressure.
Why do people use titanium valves anyway? It has been found that by lessening the valve weight of an engine, there is a big impact on the reliability of an engine, as well as its performance and longevity. There have been studies that showed the performance of an engine that has steel valves compared to one that has titanium ones. Based on the sound, an engine that has titanium ones is able to accelerate a lot more smoothly. This is due to the ability of the valve springs to keep what they call the "valvetrain" under control. When the valve weight is reduced, valve springs also tend to last a lot longer, and the lifters of the engine also become more reliable. Not to mention, engines that are overhauled and fitted with valves made of titanium look a lot better than those with steel valves do. When people also use titanium valves, they will see visible results. They will be able to see that there is less wear and tear on what is called the "camshaft drive", whether it is a belt, gears, or chain.