Home / Valves / 3 Way Diverter Valves / High Pressure Inline Check Valve Pilot Operated Check Valve Hydraulic Locking Cylinder Position Parker Valve Pilot Operated Check Valve Animation Servo Valve Symbol
Edwina Dorsey Valves April 14th, 2019 - 12:31:15
The first category is the most common one. A ball in the shell of the valve fits tightly against the side of the valve where the water comes in. Water pushing through the pipe moves the ball against the spring, allowing water through the valve. When the water is turned off, the ball is pushed into place by the spring and keeps water from flowing backward through the pipe.
Nowadays, positioners are used with the majority of control valve applications. They allow for precise positioning accuracy and faster response to process upsets when used with a conventional digital control system. The most important characteristic of a good positioner for process variability reduction is that it be a high gain device.
In addition to the valve positioners, valve products themselves deserve our attention. There are many categories. Among all those valve types, the check valve is one of the main kinds. It is used to close off piping and to prevent backflow. Backflow occurs when the substance in the pipe flows in the opposite direction when the valve is closed. There are many forms of this type of valves such as ball check valves, stop-check valve, cone check valves, and disk check valve and so on.
Among all the above mentioned considerations, it is rather necessary to talk about the actuator and positioner design. These two must be considered together. The combination of them affects the static performance (dead band), as well as the dynamic response of the control valve assembly and the overall air consumption of the valve instrumentation.
Needle Valves are used whenever control or metering of steam, air, gas, oil, water or other non-viscous liquids is required. This means they are used in almost every industry over a massive range of applications. Swagelok Valves are all factory tested with nitrogen at 1000 psig (69) bar to ensure that seats have a maximum allowable leak rate of 0.1 stdcm3/minute, and shell testing is performed to a requirement of no detectable leakage with a liquid leak detector.
With the rapid development of different industries such as modern nuclear, petrochemical, electric and space, automatic control for process technology and long-distance fluid transportation, a lot of modern low-temperature valve, vacuum valve and control valve are in great need. So in order to ensure the good sealability and suitable strength of the above-mentioned valves, to develop new materials will be a great challenge. As it should be, just to improve the sealing ability and strength for future valves is not enough. It is suggested that the manufactures should expand other parameters of the valve and develop energy-saving, automatic and multi-functional valves, such as low-temperature one used for liquid oxygen, hydrogen or natural gas, vacuum valve, safe valve and so on